Zoom 8080 - Manual (Page 37)

■ 36
Advanced
Operation
In Play mode, press
the three
times to call up the
page shown below.
This is the page for selecting the
function of the USER FUNCTION
switch.
UTILITY/PAGE key
1
Verify that the "USER
FUNCTION=" item is
set to "MANUAL". If not, use Data entry knob 2 to
select the setting.
2
Press the
four
times to
call up the page
shown below.
This is the page for selecting the
effect modules to be assigned to
foot switches 1-3.
UTILITY/PAGE key
3
CONTROL
PEDAL
CONTROL
PEDAL
CONTROL
SWITCH
DECREASE
–(TAP/HOLD)
INCREASE
BANK
MAX
CONTROL SWITCH INDICATOR
1/2
MIN
BLINK
(DLY:TAP)
COMP EFF1 DIST EQ EFF2 EFF3 DLY REV TOTAL
EDIT
EXIT TYPE – +
PRESENCE OUTPUT
GROUP COMPARE
FINE TUNE
Super ADVANCED GUITAR EFFECTS PROCESSOR
STORE (EXECUTE)
3 4
1 2
MAX MIN
MAX MIN MAX MIN
MAX MIN
UTILITY PAGE
USER
FUNCTION
2, 4, 6
8
7
1, 3, 5
Display
STORE/EXECUTE key
STORE
(EXECUTE)
9
Foot switches 1-5
USER FUNCTION switch
USER
FUNCTION
MAX MIN
Data entry knobs 1-4
UTILITY
PAGE
UTILITY/PAGE key
USER FUNCTION=MANUAL
3
Fsw ASSIGN: SW1=EF1
7 SW2=DST SW3=EF2
The USER FUNCTION switch can be programmed by the user to perform a desired function. The following
four functions are available: switch between Play mode and Manual mode, call up a predefined bank number,
call up a predefined patch number, switch between PRESET groups A/B/C.
In the factory default condition, the switch is set to select PRESET groups.
In Manual mode, the foot switches 1-5 can be used to turn predefined effect modules on and off. To do this, the
following steps are required.
• In Utility mode, set the USER FUNCTION switch parameter to "MANUAL".
• In Utility mode, assign the desired effect modules to foot switches 1-5.
To switch between Play mode and Manual mode with the USER FUNCTION switch
Using the USER FUNCTION Switch