Zoom 8080 - Manual (Page 25)

Using CONTROL pedals 1 and 2 to continuously adjust parameters such as volume or wah can be very effective
during a performance. To do this, the following steps are required.
• In the TOTAL module, select the effect module to be assigned to CONTROL pedal 1 and 2.
• Within the selected effect module, select the parameter to be controlled and the change direction.
The 8080 incorporates a so-called RTM (real-time modulation) function which lets the user change effect
parameters in real time. During a performance, the CONTROL pedals 1 and 2 and the CONTROL switches can
be used to change previously determined effect module parameters.
■ 24
Advanced
Operation
Using the CONTROL pedals for RTM
In Play mode, press
the . The 8080 enters the Edit mode. If
the TOTAL key is not flashing, press
the TOTAL key to select the TOTAL
parameters.
EDIT/EXIT key
1
Press the
once.
UTILITY/PAGE key
2
Use 3 to
select the effect
module to assign to
.
This page serves to assign effect
modules to the CONTROL switches
(data entry knob 2), CONTROL
pedal 1 (data entry knob 3) and
CONTROL pedal 2 (data entry knob
4).
The illustration below shows an
example for assigning the EF3 effect
module to CONTROL pedal 1.
CONTROL pedal 1
CONTROL
PEDAL
Data entry knob 3
CONTROL
PEDAL CONTROL
SWITCH
DECREASE
–(TAP/HOLD)
INCREASE
USER
FUNCTION BANK
MAX
CONTROL SWITCH INDICATOR
1/2
MIN
BLINK
(DLY:TAP)
EFF1 DIST EQ EFF2 EFF3 DLY REV
TYPE – +
PRESENCE OUTPUT
GROUP COMPARE
FINE TUNE
Super ADVANCED GUITAR EFFECTS PROCESSOR
CONTROL
PEDAL
COMP TOTAL
UTILITY PAGE
3 4
1 2
MAX MIN
MAX MIN MAX MIN
MAX MIN
EDIT
EXIT STORE (EXECUTE)
1
9
4
2, 5
3, 6, 7
Display
TOTAL
TOTAL key
EDIT
EXIT
EDIT/EXIT key
CONTROL PEDAL
CONTROL pedal 1
UTILITY
PAGE UTILITY/PAGE key
MAX MIN
Data entry knobs 1-4
Effect key COMP
8
STORE/EXECUTE key
STORE
(EXECUTE)
CONTROL SET: CSW=DLY
2 CP1=VOL CP2=OFF
CONTROL SET: CSW=DLY
é 2 CP1=EF3 CP2=OFF
SERIAL/PARALLEL:
1 EF2 EF3
Using the RTM Function
In the factory default condition, CONTROL pedal 1 is set to adjust the volume of each patch and CONTROL pedal 2 can be
assigned to various parameters with the CONTROL switches. Before you make any changes, we suggest to try this out for yourself.
HINT HINT
Press the for
the effect module
assigned to the
CONTROL pedal to
display the
parameters of that
module.
Effect key 4
FLG DPT=50 SPD= 50
é FB= 0 MAN= 0