Zoom 8080 - Manual (Page 29)

The DECREASE CONTROL switch can be used to set the delay time of the delay module by tapping. To do
this, the following steps are required.
• In the TOTAL module, select the DLY effect module to be assigned to the CONTROL switches.
• Within the DLY effect module, set the CSW parameter to "Tap".
■ 28
Advanced
Operation
Tapping input of delay time
In Play mode, press
the . The 8080 enters the Edit mode. If
the TOTAL key is not flashing, press
the TOTAL key to select the TOTAL
parameters.
EDIT/EXIT key
1
Press the
once. UTILITY/PAGE key 2
Use 2 to
set the CSW
parameter to "DLY".
Data entry knob 3
Press the DLY
to select the delay
module.
Effect key 4
CONTROL
PEDAL
USER
FUNCTION BANK
MAX
CONTROL SWITCH INDICATOR
1/2
MIN
BLINK
(DLY:TAP)
EFF1 DIST EQ EFF2 EFF3
TYPE – +
PRESENCE OUTPUT
GROUP COMPARE
FINE TUNE
Super ADVANCED GUITAR EFFECTS PROCESSOR
CONTROL
PEDAL
COMP TOTAL
UTILITY PAGE
3 4
1 2
MAX MIN
MAX MIN MAX MIN
MAX MIN
EDIT
EXIT
DECREASE
–(TAP/HOLD)
INCREASE
CONTROL
SWITCH
DLY REV
STORE (EXECUTE)
1
8
4
3, 6
Display
TOTAL TOTAL key
EDIT
EXIT
EDIT/EXIT key
CONTROL switches (DECREASE)
Effect key (DLY key )
2, 5
UTILITY
PAGE
UTILITY/PAGE key
MAX MIN
Data entry knob
CONTROL
SWITCH
DECREASE
–(TAP/HOLD)
INCREASE
DLY
7
STORE/EXECUTE key
STORE
(EXECUTE)
CONTROL SET: CSW=DST
2 CP1=VOL CP2=OFF
CONTROL SET: CSW=DLY
é 2 CP1=VOL CP2=OFF
DLY TIM=1000(mS)
é FB= 3 Mix= 30
SERIAL/PARALLEL:
1 EF2 EF3
Press the
once to
display the RTM
parameter on page 2.
UTILITY/PAGE key
5
DLY HiD= 0 SEL=MN
é RTM=Mix CSW=Mix