Zoom 8080 - Manual (Page 27)

The CONTROL switches can be used with the RTM function to alter parameters in discrete steps. This lets you
easily and quickly adjust distortion or overdrive intensity, flanger speed etc. during a performance.
To use the CONTROL switches for adjusting effect parameters, the following steps are required.
• In the TOTAL module, select the effect module to be assigned to the CONTROL switches.
• If desired, within the selected effect module, select the parameter to be controlled.
■ 26
Advanced
Operation
Using the CONTROL switches for RTM
In Play mode, press
the . The 8080 enters the Edit mode. If
the TOTAL key is not flashing, press
the TOTAL key to select the TOTAL
parameters.
EDIT/EXIT key
1
Press the
once. UTILITY/PAGE key
2
Use 2 to
select the effect
module to be
assigned to the
.
CSW is the parameter for selecting
the item to be adjusted by the
CONTROL switches.
CONTROL switches
Data entry knob 3
CONTROL
PEDAL
USER
FUNCTION BANK
MAX
TYPE – +
PRESENCE OUTPUT
GROUP COMPARE
FINE TUNE
Super ADVANCED GUITAR EFFECTS PROCESSOR
CONTROL
PEDAL
COMP TOTAL
UTILITY PAGE
3 4
1 2
MAX MIN
MAX MIN MAX MIN
MAX MIN
EDIT
EXIT
DECREASE
–(TAP/HOLD)
INCREASE
CONTROL
SWITCH
CONTROL SWITCH INDICATOR
1/2
MIN
BLINK
(DLY:TAP)
EFF1 DIST EQ EFF2 EFF3 DLY REV
STORE (EXECUTE)
1
5
2
3
Display
TOTAL
EDIT
EXIT
CONTROL SWITCH
INDICATOR
UTILITY
PAGE
MAX MIN
CONTROL
SWITCH
DECREASE
–(TAP/HOLD)
INCREASE MAX
CONTROL SWITCH INDICATOR
1/2
MIN
BLINK
(DLY:TAP)
TOTAL key
EDIT/EXIT key
CONTROL switches
(INCREASE/DECREASE)
UTILITY/PAGE key
Data entry knob 2
4
STORE/EXECUTE key
STORE
(EXECUTE)
CONTROL SET: CSW=DST
2 CP1=VOL CP2=OFF
CONTROL SET: CSW=EF1
é 2 CP1=VOL CP2=OFF
SERIAL/PARALLEL:
1 EF2 å EF3
For effect types where the RTM destination can be changed (some effect types in effect modules EFF2 and EFF3), the
parameter to be controlled can be selected at the RTM page for that module ( p. 55).
Among the effect types of the DLY module, the RTM page has a
dedicated parameter for the CONTROL switches called "CSW" (CSW
mode select). This allows use of the CONTROL switches separately
from the "RTM" (RTM destination) item ( p. 60).
NO
✎
DLY HiD= 0 TYP= MN
RTM Mix CSW=Tap
Parameters adjusted by CONTROL switches
RTM page of DLY module