ZyXEL Communications Prestige 650 - Manual (Page 39)

Prestige 650 ADSL Router
Hardware Installation and Initial Setup 2-9
1. Type atlc after the Enter Debug Mode message.
2. Wait for the Starting XMODEM upload message before activating XMODEM upload on your
terminal.
3. After a successful firmware upload, type atgo to restart the Prestige.
The Prestige is now reinitialized with a default configuration file including the default password of “1234”.
2.8.1 Methods of Restoring Factory-Defaults
You can erase the current configuration and restore factory defaults in three ways:
a. Use the web configurator (see the web configurator HTML help).
b. Upload the default configuration file via the console port as described above. See later in
this User’s Guide for more information on how to transfer the configuration file to your
Prestige using the SMT menus.
c. Use the RESET button on the rear panel of the Prestige (see the next section).
2.8.2 Procedure To Use The Reset Button
1. Turn your Prestige off and then on. Make sure the SYS led is on (not blinking).
2. Press the RESET button for five seconds and then release it. If the SYS LED begins to blink, the
defaults have been restored and the Prestige restarts.