Nat setup, 3 nat setup – ZyXEL Communications Prestige 650 User Manual
Page 94
Prestige 650 ADSL Router
7-8 NAT
Figure 7-4 Menu 11.3 — Applying NAT to the Remote Node
The following table describes the options for Network Address Translation.
Table 7-3 Applying NAT in Menus 4 & 11.3
FIELD DESCRIPTION
EXAMPLE
Press [SPACE BAR] and then [ENTER] to select Full Feature if you
have multiple public WAN IP addresses for your Prestige. The SMT
uses the address mapping set that you configure and enter in the
Address Mapping Set field (menu 15.1 - see section 7.3.1).
Full Feature
Select None to disable NAT.
None
NAT
When you select SUA Only, the SMT uses Address Mapping Set 255
(menu 15.1 - see section 7.3.1). Choose SUA Only if you have just
one public WAN IP address for your Prestige.
SUA Only
7.3 NAT
Setup
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can
only configure Set 1. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the
SMT will use Set 1, which supports all mapping types as outlined in Table 7-2. When you select SUA
Only, the SMT will use the pre-configured Set 255 (read only).
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment= Static Ethernet Addr Timeout (min)= 0
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Address Mapping Set= 2
Metric= 2
Private= No
RIP Direction= Both
Multicast= IGMP-v2
IP Policies=