ZyXEL Communications Prestige 650 - Manual (Page 80)

Prestige 650 ADSL Router
5-6 Remote Node TCP/IP Configuration
Each remote node specifies only the network to which the gateway is directly connected and the Prestige
has no knowledge of the networks beyond. For instance, the Prestige knows about network N2 in the
following figure through remote node Router 1. However, the Prestige is unable to route a packet to
network N3 because it does not know that there is a route through remote node Router 1 (via Router 2). The
static routes allow you to tell the Prestige about the networks beyond the remote nodes.
Figure 5-5 Sample Static Routing Topology
Configuration
Step 1. To configure an IP static route, use Menu 12 – Static Route Setup (shown next).
Figure 5-6 Menu 12 — Static Route Setup
Menu 12 - Static Route Setup
1. IP Static Route
3. Bridge Static Route
Please enter selection: