ZyXEL Communications Prestige 650 - Manual (Page 70)

Prestige 650 ADSL Router
4-4 Remote Node Configuration
FIELD DESCRIPTION EXAMPLE
Encapsulation PPPoE (Point-to-Point Protocol over Ethernet).
PPPoA refers to RFC-2364 (PPP Encapsulation over
ATM Adaptation Layer 5).
If RFC-1483 (Multiprotocol Encapsulation over ATM
Adaptation Layer 5) of ENET ENCAP are selected,
then the Rem Login, Rem Password, My Login, My
Password, Edit PPP Options and Authen fields are not
applicable (N/A). PPPoE
Multiplexing Press [SPACE BAR] and then [ENTER] to select the
method of multiplexing that your ISP uses, either VC-
based or LLC-based. LLC-based
Service Name When using PPPoE encapsulation, type the name of
your PPPoE service here.
Incoming:
Rem Login
Type the login name that this remote node will use to
call your Prestige. The login name and the Rem
Password will be used to authenticate this node.
Rem Password Type the password used when this remote node calls
your Prestige.
Outgoing:
My Login
Type the login name assigned by your ISP when the
Prestige calls this remote node.
My Password Type the password assigned by your ISP when the
Prestige calls this remote node.
This field sets the authentication protocol used for
outgoing calls. Options for this field are:
CHAP/PAP – Your Prestige will accept either CHAP or
PAP when requested by this remote node.
CHAP – accept CHAP (Challenge Handshake
Authentication Protocol) only. CHAP/PAP
Authen
PAP – accept PAP (Password Authentication Protocol)
only.
Route This field determines the protocol used in routing.
Options are IP and None. IP
Bridge When bridging is enabled, your Prestige will forward any
packet that it does not route to this remote node;
otherwise, the packets are discarded. Select Yes to
enable and No to disable. No