ZyXEL Communications Prestige 650 User Manual
Page 64
Prestige 650 ADSL Router
3-16
Internet Access
FIELD DESCRIPTION
EXAMPLE
Sustain Cell Rate
(SCR)= 0
Sustained Cell Rate is the mean cell rate of a bursty, on-off
traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic. Type the SCR; it must be less
than the PCR.
0
Maximum Burst Size
(MBS)= 0
Refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS. The MBS must be less than 65535.
0
My Login
Configure the My Login and My Password fields for PPPoA
and PPPoE encapsulation only. Enter the login name that your
ISP gives you. If you are using PPPoE encapsulation, then
this field must be of the form
identifies your PPPoE service name.
N/A
My Password
Enter the password associated with the login name above.
N/A
ENET ENCAP
Gateway
Enter the gateway IP address supplied by your ISP when you
are using ENET ENCAP encapsulation.
N/A
Idle Timeout
This value specifies the number of idle seconds that elapse
before the Prestige automatically disconnects the PPPoE
session.
100
(default)
IP Address
Assignment
Press [
SPACE BAR
] to select Static or Dynamic address
assignment.
Static
IP Address Enter the IP address supplied by your ISP if applicable.
0.0.0.0
Network Address
Translation
Press [
SPACE BAR
] to select None, SUA Only or Full
Feature. Please see the NAT Chapter for more details on the
SUA (Single User Account) feature.
SUA Only
Address Mapping Set Type the numbers of mapping sets (1-8) to use with NAT. See
the NAT chapter for details.
N/A
When you have completed this menu, press [
ENTER
] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [
ESC
] at any time to cancel.
If all your settings are correct your Prestige should connect automatically to the Internet. If the connection
fails, note the error message that you receive on the screen and take the appropriate troubleshooting steps.