ZyXEL Communications ZyXEL Dimension ES-2108 - Manual (Page 207)

ES-2108 Series User’s Guide
Chapter 30 Introducing Commands 207
pvid <1-4094> The default PVID is VLAN 1 for all ports.
Sets a PVID in the range 1 to 4094 for the
specified interface.
13
gvrp Enables this function to permit VLAN
groups beyond the local switch.
13
frame-type
<all|tagged>
Choose to accept both tagged and
untagged incoming frames or just tagged
incoming frames on a port.
13
name <port-
name-string>
Sets a name for the port(s). Enter a
descriptive name (up to nine printable
ASCII characters).
13
vlan-trunking Enables VLAN Trunking on ports
connected to other switches or routers
(but not ports directly connected to end
users) to allow frames belonging to
unknown VLAN groups to pass through
the switch.
13
flow-control Enables interface flow control. Flow
control regulates transmissions to match
the bandwidth of the receiving port.
13
bandwidth-
limit
Enables ingress (pir), cir and egress limits
on the port(s).
13
ingress Enables limits for incoming traffic on the
port(s).
13
ingress
<Kbps>
Sets the maximum bandwidth allowed for
incoming traffic on the port(s).
13
egress Enables bandwidth limits allowed for
outgoing traffic on the port(s).
13
egress <Kbps> Sets the maximum bandwidth allowed for
outgoing traffic on the port(s).
13
bmstorm-limit Enables broadcast storm limits on the
switch.
13
<Kbps> Specifies the maximum amount of
bandwidth allowed for broadcast traffic.
13
diffserv Enables DiffServ on the port(s). 13
qos priority <0 .. 7> Sets the quality of service priority for an
interface.
13
mirror Enables port mirroring in the interface. 13
dir
<ingress|egre
ss|both>
Enables port mirroring for incoming,
outgoing or both incoming and outgoing
traffic.
Port mirroring copies traffic from one or all
ports to another or all ports for external
analysis.
13
Table 75 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE