Figure 107 windows xp: advanced tcp/ip settings – ZyXEL Communications ZyXEL AG-220 User Manual
Page 127
ZyXEL AG-220 User’s Guide
Appendix E
127
•
If you have a static IP address click Use the following IP Address
and fill in the IP address, Subnet mask, and Default gateway fields.
Click Advanced.
Figure 107 Windows XP: Advanced TCP/IP Settings
6 If you do not know your gateway's IP address, remove any previously installed gateways
in the IP Settings tab and click OK.
Do one or more of the following if you want to configure additional IP addresses:
•
In the IP Settings tab, in IP addresses, click Add.
•
In TCP/IP Address, type an IP address in IP address and a subnet
mask in Subnet mask, and then click Add.
•
Repeat the above two steps for each IP address you want to add.
•
Configure additional default gateways in the IP Settings tab by
clicking Add in Default gateways.
•
In TCP/IP Gateway Address, type the IP address of the default
gateway in Gateway. To manually configure a default metric (the
number of transmission hops), clear the Automatic metric check box
and type a metric in Metric.
•
Click Add.
•
Repeat the previous three steps for each default gateway you want to
add.
•
Click OK when finished.
7 In the Internet Protocol TCP/IP Properties window (the General tab in Windows XP):