ZyXEL Communications ZyXEL AG-220 - Manual (Page 78)

ZyXEL AG-220 User’s Guide
78 Chapter 5 Access Point Mode Configuration
Figure 52 Access Point Mode: Advanced
The following table describes the labels in this screen.
5.5 The MAC Filter Screen
The MAC Filter screen allows you to configure the AG-220 to give exclusive access to
devices (Accept) or exclude devices from connecting to the AG-220 (Reject). The MAC
address is assigned at the factory and consists of six pairs of hexadecimal characters, for
example, 00:A0:C5:00:00:02. You need to know the MAC address of the device(s) to
configure this screen. See
Section 3.2.2 on page 38 for more information.
Table 20 Access Point Mode: Advanced
LABEL DESCRIPTION
Advanced Setting
Frequency Choose a network mode. Select 802.11b+g to have your AG-220 connect to
other wireless devices in either IEEE 802.11 b or 802.11g modes. Alternatively,
select 802.11g, 802.11b or 802.11a to have your AG-220 connect to other
wireless devices in b, g or a mode only.
Save Click Save to save the changes to the AG-220. If you are connected to a
wireless network when changing network modes, the AG-220 will disconnect
and then attempt to reestablish the connection using the new setting.