1 using peap in vista, 2 using tls in vista – ZyXEL Communications ZyXEL AG-220 User Manual
Page 70
ZyXEL AG-220 User’s Guide
70
Chapter 4 Wireless Station Mode Configuration
4.8.1 Using PEAP in Vista
Take the following steps to set up WPA, WPA2 or 802.1x security using PEAP in Windows
Vista.
1 Either select the AP to which you want to connect in the Site Survey screen (see
), or configure a profile in the normal way (see
2 In the WPA, WPA2 or 802.1x security screen (see
and
), select PEAP as the EAP Type. Note that the Login Name,
Logon Domain, and Password fields are not available in the Vista utility, you will be
able to enter them in the Vista Security screen below.
3 Click Next.
4 In the Summary screen that appears, click Save.
5 A message similar to the following appears in the bottom-right of your screen. Click the
message.
Figure 45 Vista Security: Additional Information Required
6 The Enter Credentials screen displays. Enter your User name and Password for the
network to which you want to connect.
Figure 46 Vista Security: Enter Credentials
Note: If you are not sure what to enter, contact your network administrator.
7 Click OK. The Enter Credentials screen disappears and the AG-220 tries to connect to
the network. The ZyXEL utility’s Link Info screen displays, showing the connection
status (see
). If the Link Info screen displays an active
connection, you have successfully completed the procedure.
4.8.2 Using TLS in Vista
Take the following steps to set up WPA, WPA2 or 802.1x security using TLS in Windows
Vista.