Zebra Technologies R170XiTM - Manual (Page 128)

116 R110Xi/R170Xi User Guide 23063L-003 Rev. 2 12/23/04
Routine Maintenance
Cleaning Schedule
Cleaning Schedule
The recommended cleaning schedule is shown in Table 13 . See the following pages for
specific procedures.
Clean Exterior
Clean the outside surfaces of the printer with a lint-free cloth. Use a mild detergent solution or
desktop cleaner sparingly, as needed.
Caution • Use only the cleaning agents indicated. Zebra is not responsible for damage
caused by any other fluids being used on this printer.
Table 13 • Recommended Printer Cleaning Schedule
Area Method Interval
Printhead Solvent* Perform these procedures at the following times:
• When
CLEAN HEAD NOW appears.
• Direct Thermal Print Mode: After every roll of labels
or 500 ft (150 m) of fanfold labels.
• Thermal Transfer Print Mode: After every roll
(1500 ft or 450 m) of ribbon.
Platen roller Solvent*
Transmissive (media) sensor Air blow
Media path Solvent*
Ribbon sensor Air blow
Label-available sensors Air blow Monthly
Tear-off bar Solvent*
Snap plate Solvent* As needed
* Use Preventative Maintenance kit, part number 47362, or a solution of 90% isopropyl alcohol and 10%
deionized water.
Caution • Do not use harsh or abrasive cleaning agents or solvents.