Zebra Technologies R170XiTM - Manual (Page 133)

Routine Maintenance
Clean Interior
23063L-003 Rev. 2 12/23/04 R110Xi/R170Xi User Guide 121
Snap Plate
Clean the snap plate when label adhesive or a label is stuck to the underside. Figure 47 shows
the location of the snap plate
Figure 47 • Snap Plate Location
To clean the snap plate, complete these steps:
1. Remove the two screws that secure the snap plate to the antenna support frame.
2. Remove the snap plate from the printer.
3. Clean the snap plate with cleaning solvent and a soft cloth.
4. To reinstall the snap plate, slide it back into place until the screw holes on the snap plate
line up with the screw holes in the antenna support frame.
5. Reinstall the two snap plate screws to secure the snap plate to the antenna support frame.
1 Antenna support screws
2 Location of right-side snap plate screw
(screw not shown)
3 Snap plate
4 Antenna support
5 Antenna support frame
6 Left-side snap plate screw
1
6
5
2
4
3
Important • Do not remove the antenna support screws.