Zebra Technologies R170XiTM - Manual (Page 140)

128 R110Xi/R170Xi User Guide 23063L-003 Rev. 2 12/23/04
Troubleshooting
LCD Error Messages
RIBBON IN Ribbon is loaded, but the printer
is set for Direct Thermal mode. • To operate in Direct Thermal mode, remove the
ribbon.
• To operate in Thermal Transfer mode, leave the
ribbon loaded and change the print method to
Thermal Transfer. See
Selecting Print Method
on page 46 .
• Ensure that the printer driver and/or software
settings are correctly set (if applicable).
HEAD TOO HOT The printhead is over
temperature. Printing automatically resumes when the printhead
elements cool to an acceptable operating
temperature.
Caution • The printhead is hot and can
cause severe burns. Allow the printhead
to cool.
Caution • Observe proper electrostatic
safety precautions when handling any
static-sensitive components such as
circuit boards and printheads.
CLEAN HEAD NOW The printhead requires
cleaning. Clean the printhead according to the instructions in
Printhead and Platen Roller on page 117 .
Caution • The printhead is hot and can
cause severe burns. Allow the printhead
to cool.
Caution • Observe proper electrostatic
safety precautions when handling any
static-sensitive components such as
circuit boards and printheads.
If the message does not go away after the printhead
is cleaned, open the printhead and then close it.
Table 14 • LCD Error Messages (Continued)
LCD Possible Cause Recommended Solution