Z Microsystems 19 - Manual (Page 10)

Doc# 27-0023UM Rev 1.0 Issued 09/04
10
INSTALLATION
FINAL ADJUSTMENTS OF THE COMMAND CONSOLE
Slide the Console partially
out.
Use a fl athead screw
driver to slightly move the
Z-Locks out away from the
Console.
Tighten all the screws on
the front Z-Lock mounts.
Slide the Console in and
out to see if it moves
smoothly.
Go back to the rear of
the rack and fully tighten
the slide extension rail
screws. Loosen the screws on each
of the front Z-Lock mounts.
NOTE: A wrench may
be necessary to
hold the nut on
the other side.