Z Microsystems 19 - Manual (Page 6)

Doc# 27-0023UM Rev 1.0 Issued 09/04
6
INSTALLATION
NOTE: For the fastest and easiest
installation of the Command
Console, follow these steps
in the sequence they are
presented.
Ensure all of the following parts are in-
cluded in the package received from Z Mi-
crosystems. Verify all parts have not been
damaged during shipment. If any of the
parts are missing or damaged, immediately
contact Z Microsystems Customer Service
at 858-657-1000.
• Command Console unit attached to the
mounting plate
• Hardware kit
• Manual
• Power Supply Cable
• Video Signal Cable
• Serial I/O Cable
• CD of SoftMenu software
SHIPMENT CONTENTS
Remember to save the unit’s original
shipping materials. It may be necessary to
move the unit at a later date.
TOOLS REQUIRED PRECAUTIONS
• Required Tools and Equipment
• Flathead screwdriver with about 10”
shaft.
• Phillips screwdriver with about 10”
shaft.
In preparation to install the Command Con-
sole, take the following precautionary step:
Turn off the electrical power to your com-
puter.
DANGER: To avoid shock
hazard:
• Do not remove the covers around the
Command Console.
• Do not connect or disconnect the
Command Console during an electrical
storm.
• Th e power cord plug must be connected
to a properly wired and grounded power
outlet.
• Any equipment to which the Command
Console will be attached must also be
connected to properly wired and grounded
power outlets.