Z Microsystems 19 - Manual (Page 9)

Doc# 27-0023UM Rev 1.0 Issued 09/04
9
APPENDIX
INSTALLATION
INSTALL THE COMMAND CONSOLE IN THE SLIDES
Pull the two Console slides
out until they lock. Hold the Console by each
side, with the front toward
you.
Feed the four cables com-
ing out of the Console back
through the cabinet frame.
Guide the Console into the
slides and slide the Con-
sole in until it stops.
Simultaneously press in
the catches on each slide
and slide the Console all
the way into the cabinet
frame.
The Console should slide
in and out easily.
Slide the Console in and
out several times.
The Console should easily
close completely.
To be sure the slide and
mount assembly are
aligned properly, slide the
Console in and out several
times.
If the Console binds during
sliding, do the following:
Because of variances in
cabinet frames, there may
need to be some adjust-
ments of the Console slide
system for best fi t and
movement of the Console
in and out.
TEST INSTALLATION AND MAKE ADJUSTMENTS