3Com 3C319 - Manual (Page 26)

2-6 C HAPTER 2: I NSTALLING THE 3C319 NIC
■
If you installed the 3C319 NIC in a PC running
Windows 95 with PnP, it will be configured
automatically when you install the driver. See
Chapter 4 , “Installing a Network Driver for
Windows 95 .”
After installing the NDIS 4 driver for Windows 95, you
have the option to enable DynamicAccess Class of
Service support for the 3C319 NIC. See
Chapter 7 ,
“Configuring DynamicAccess Class of Service .”
■
If you installed the 3C319 NIC in a PC running
Windows NT, disable PnP before installing the driver.
See
Chapter 5 , “Configuring the NIC Manually,” for
instructions on disabling PnP. For Windows NT driver
installation instructions, see
Chapter 6 , “Installing a
Network Driver for Windows NT.”
After installing the NDIS 4 driver for Windows NT, you
have the option to enable DynamicAccess Class of
Service support for the 3C319 NIC. See
Chapter 7 ,
“Configuring DynamicAccess Class of Service.”
■
If you installed the 3C319 NIC in a PC running
Windows for Workgroups with PnP, disable PnP before
installing the driver. See
Chapter 5 , “Configuring the
NIC Manually,” for instructions on disabling PnP.
For Windows for Workgroups driver installation
information, see
“Installing a Driver for Windows for
Workgroups” in Chapter 8 .
■
If you installed the 3C319 NIC in a PC without PnP, or
installed the NIC in a PC with a BIOS that does not
have a utility to recognize and configure PnP-enabled
devices, you must manually configure the NIC before
installing the driver. See
Chapter 5 , “Configuring the
NIC Manually,” and then see Chapter 8 , “Manually
Installing Miscellaneous Network Drivers.”
Table 2-2 summarizes the installation procedures for
supported network environments.