3Com 3C319 - Manual (Page 37)

Installing the NDIS 4 Driver for Windows 95 4-5
2 In the My Computer group, double-click the
Control Panel icon.
3 In the Control Panel group, double-click the
Network icon.
4 In the Network dialog box, click Add.
5 In the Select Network Component Type dialog box,
double-click Adapter.
6 In the Select Network Adapters dialog box, click
Have Disk.
7 Insert TokenDisk diskette #2 in the floppy drive.
8 In the Copy Manufacturer’s Files From selection
box, type:
a:\
9 Click OK.
10 In the Models selection box, select the correct
mode (either ISA or EISA).
■
Select 3Com TokenLink Velocity ISA 3C319 if you
installed the NIC in an ISA slot. You can also make this
selection if the NIC is in an EISA slot as long as you
have not enabled the AutoSwitch option. (For more
information about enabling the AutoSwitch option,
see instructions in the section
“Other Configuration
Options ” in Chapter 5 .)
■
Select 3Com TokenLink Velocity ISA 3C319 in EISA
mode only if you installed the NIC in an EISA slot
and used the EISA configuration utility to configure
the NIC.
In a Compaq EISA-based PC, with PnP enabled on the
NIC, you are asked to run the EISA configuration utility.
Refer to the instructions that accompanied the PC
for details.
11 Click OK.
12 In the Network dialog box, click OK.
13 On the Resources screen, click OK to accept the I/O
base address.