3Com 3C319 - Manual (Page 45)

Changing Configuration Option Settings 5-5
Changing Configuration Option Settings
PnP is enabled by default. You must disable PnP to
configure the 3C319 NIC with the Configuration and
Diagnostic Program.
To disable PnP for the 3C319 NIC and change the
configuration settings, follow these steps:
1 Insert TokenDisk diskette #1 in the floppy drive (for
example, the A drive) and type:
a:\3trdiag [Enter]
2 Select Install and press [Enter].
3 Press [Enter] to select Configure NIC.
The screen shown in Figure 5-2 appears.
Figure 5-2 NIC Configuration Screen
4 If Plug and Play is enabled, use the arrow keys to
select Plug and Play and press [Enter] to disable it.
5 Use the arrow keys to select another parameter
and press [Enter].
A second dialog box appears to allow you to make
your choice.
Diagnostic and Manual Configuration Program Version 2.0
Install Quit View Select
NIC Configuration
F1=Help
[ENTER]=Change the Setting
[
↑↓ ]=Scroll
[Alt]+<Highlighted Key>=Execute Function
Test
C ancel O K M odify F ile Options
TokenLink Velocity NIC C onfiguration
Enabled
3Com
300h
5
16 Mbps
CC000h
D8000h-DBFFFh
16 bit
16 bit
Edge Triggered
Disabled Plug and Play
Configuration Mode
l/O Base Address
Interrupt Request Level
Ring Speed
BIOS/MMIO Base Address
Shared RAM Address Range
Memory Mode
I/O Mode
IRQ Driver Type
Auto Switch