3Com Network Video Server FlexWATCH 3110 - Manual (Page 40)

Network Video Server User’s Manual
Seyeon Tech Co., Ltd 40
displayed.
Video Source: color and Gray mode option
Image Quality: 5 quality levels - highest, high, normal, low, lowest
)
Note
Please note that if you increase image size and quality, actual JPEG file size will be
increased and this may affect actual transmission frame rate. Thus, you are required to
check out your network bandwidth available for FlexWATCH
TM server and select the right
size and quality of video.
Motion Detection : Refer to description about Motion detection feature below.
Time stamp : Date and Time information can be engraved in the JPEG Image. It is
recommended to use time stamp only when you need image with built-in time info.
)
Note that once Time stamp is enabled, over all transmission speed can be
degraded.
3.3 Video Motion Detection
Built-in motion detection function is supported by the FlexWATCH TM server so that server
can sense the motion in the picture and trigger any services such as e-mail, FTP or alarm
buffering services.
Up to 144 square blocks can be configured as a motion area so that you can
flexibly filter out motion area.
3.3.1 Setting procedure
1) Go to “Camera & Motion” option in the Admin Menu
2) Select the camera for video configuration
3) Click “Select Area” button from the Camera configuration menu
4) Click the square block to set up motion detection area
5) Adjust Motion sensitivity (the lower the number, the higher the motion
sensitivity)
6) Check “Motion Enable” check box and Click “Apply” button to save your
configuration
- INTPLUS [2005] -