3Com Network Video Server FlexWATCH 3110 - Manual (Page 70)

Network Video Server User’s Manual
Seyeon Tech Co., Ltd 70
A. By-pass command string from third party
This is to send command string from third party application program to the target
device connected to the server. More about this function can be supplied by HTTP CGI
API guide.
B. Control panel inside of the system
You can create control panel of external device inside of the server and control target
device through server web page.
This function is not for general use. Thus, if you need more information about this, please
contact your local distributor or manufacturer for further information,
[email protected] .
2.4 PTZ device connection and configuration
PTZ(Pan/Tilt/Zoom) device connected to the server can be controlled through either
standard web browser or specific application program over IP network.
2.4.1 PTZ connection
When you install a RS-485/422 interfaced PTZ model:
PTZ device has to be connected to RS422/485 Port with RJ-45 connector.
And it can be configured either in AUX or COM part. As mentioned above
please check whether AUX or COM port for RS-232 is already
assigned or not and use different part for RS-422/RS-485
connection which is not assigned by RS-232 Port.
When you select PTZ at AUX part,
make use of Pin No. 1 and 2 from RS422/485 port.
When you select PTZ at COM part,
make use of Pin No. 5 and 6 from RS422/485 port.
When you install a RS-232 interfaced PTZ model:
PTZ device has to be connected to AUX or COM Port with RS-232 Serial Cable.
Standard RS-232 cable can be used to connect AUX or COM port.
1) Connect your PTZ device into RS232 (COM or AUX) port as above explanation.
AUX
M d
COM
M d
1 2 3 4 5 6 7 8
+
-
+
-
+
-
+
-
TX TX RX RX TX TX RX RX
AUX
- INTPLUS [2005] -