3Com Network Video Server FlexWATCH 3110 - Manual (Page 71)

Network Video Server User’s Manual
Seyeon Tech Co., Ltd 71
2) Go to Admin Menu >> System Configuration >> Serial Ports Configuration.
3) Select ‘PTZ’ at COM or AUX mode, and click ‘Apply’ button.
4) System reboot will be recommended, then click ‘Reboot’ button.
5) After rebooting, Go to Admin Menu >> System Configuration >> Serial Ports
Configuration.
6) Click “PTZ Mode”, then following window will show up
7) Select the installed PTZ Model on the dropdown menu as above.
8) Select the Channel number installed with the PTZ, and click ‘Apply’ button
2.4.2 Supported PTZ(Pan/Tilt/Zoom) Device list
• Following is list of PTZ devices which are directly supported by
FlexWATCH TM server. Note that some of PTZ has not been field approved, although manufacturer
integrated its protocol into FlexWATCH TM server. Thus, it is highly recommended for you to use only
field approved PTZ device.
• In addition, although Manufacturer integrated Protocol of PTZ device and did field test, PTZ can
not be workable, since PTZ manufacturer can change its protocol or other functions. Thus, it is
highly recommended for you to contact your distributor or [email protected] to make sure its
connectivity through FlexWATCH TM server.
• You are also required to refer to Technical note for installation guide per respective PTZ device
in the CD manual.
Supported PTZ List by FlexWATCH
TM
Server
- INTPLUS [2005] -