3Com Network Video Server FlexWATCH 3110 - Manual (Page 69)

Network Video Server User’s Manual
Seyeon Tech Co., Ltd 69
G. After setting up the parameters in the each filed, click ‘Apply’ button. Note that if
you are using X10 device protocol, you do not need to set up parameters, but
simple select X10 “Enable” option.
2.3.2 X 10 device & Z256
X10 and Z256 is a protocol name of Device which is to control electronic devices over the
Power line communications. Using this control mode, you can build up a system to
control any electronic device over the TCP/IP network through FlexWATCH
TM server
This function is highly recommended for Home automation or remote device control
application.
This function is not for general use. Thus, if you need more se information about this,
please contact your local distributor or manufacturer for further information,
[email protected] .
2.3.3 UART(Universal Asynchronous Receiver Transmitter) device
By-pass command mode is supported by the system so that user can send command
string to target device through the server from the remote area.
By-pass command string can be sent either by third party application program or control
panel inside of the system.
- INTPLUS [2005] -