3Com Wireless LAN Controller WX2200 - Manual (Page 157)

Perform Basic Administrative Tasks 157
To verify your deployment
1 Leave the Devices tool bar option selected.
2 Look in the Deploy Status column for the switch(es) to which you
deployed configuration information. The status should be Deploy
Completed.
You also can verify successful deployment by checking the operation log.
To access the log:
1 Select the Devices tool bar option.
2 At the bottom of the Task List panel, select Device Operations.
3 In the Task List panel, select View Operation Log.
Perform Basic
Administrative
Tasks This section contains information about basic administrative tasks you can
perform in 3WXM.
For detailed information about performing administrative tasks including
configuring WX switch management services, see the chapter
“Configuring WX System and Administrative Parameters” in the
Wireless
LAN Switch Manager Reference Manual .
For more information about image and file management, see the chapter
“Managing WX System Images and Configurations” in the
Wireless LAN
Switch Manager Reference Manual .
Configuring WX
Management
Services
You can configure the following information and management services
for the WX switch:
„
System information—You can specify system contact information, as
well as the CLI prompt and the banner message that appears at each
session.
„
HTTPS—By default, HTTPS is enabled. TCP port 443 is used for secure
access by Web Management, the 3Com Web-based application for
managing a WX switch.
3WXM communications also use HTTPS, but 3WXM is not affected by the
HTTPS configuration on the WX. For 3WXM, HTTPS is always enabled and
listens to port 8889.
„
Telnet—By default, Telnet is disabled. You can enable Telnet for
unencrypted access to the CLI.