Placing ports in a port trunk, Placing ports in a port trun – 3Com 1100 User Manual
Page 159
Placing Ports in a Port Trunk
159
When setting up a port trunk, note that:
■
The ports at both ends of a connection must be configured as trunk
ports.
■
The trunk ports can only belong to one port trunk.
■
The trunk ports must be fiber or twisted pair ports.
■
The trunk ports must be from the same Switch in the stack.
■
The trunk ports must have an identical configuration. Port speed is the
only exception — if ports of a different speed are trunked together,
the higher speed links carry the traffic. The lower speed links only
carry the traffic if the higher speed links fail.
■
The ports in a trunk do not support security, VLT tagging, resilient
links, or roving analysis. For information about security, see
. For information about VLT tagging,
see
“Placing a Port in Multiple VLANs”
. For information
about resilient links, see
page 79
. For
information about roving analysis, see
.
■
Port trunks cannot have a permanent entry placed against them in the
Switch Database.
When using a port trunk, note that:
■
To gather statistics about a port trunk, you must add together the
statistics for each port in the trunk.
■
To disable a link in a port trunk, you must remove the connection and
then disable both trunk ports in the link separately. If you do this, the
traffic destined for that link is distributed to the other links in the port
trunk. If you do not remove the connection and only disable one trunk
port in the link, traffic is still forwarded to that port by the trunk port
at the other end. This means that a significant amount of traffic may
be lost.
■
Before removing a port trunk, you must disable all the trunk ports or
disconnect all the links — if you do not, a loop may be created.
Placing Ports in a
Port Trunk
To place ports into a port trunk, use the Port Trunk Setup page of the web
interface; for more information, see
on
.