3Com 1100 - Manual (Page 29)

Default Settings 29
Default Settings Table 4 shows the default settings of units in the Switch 1100/3300 and
610/630 family. If you initialize one of these Switch units, it is returned to
these defaults.
Table 4 Default Settings
Switch 1100/610 Family Switch 3300/630 Family
Port Status Enabled Enabled
Port Speed 10BASE-T/
100BASE-TX ports are
auto-negotiated. 10BASE-T/100BASE-TX ports are
auto-negotiated; 1000BASE-T
and 1000BASE-SX ports are
permanently fixed at 1000Mbps
Forwarding
Mode Intelligent Store-and-forward
Duplex Mode All fixed 10BASE-T and
10BASE-T/100BASE-TX ports are
auto-negotiated. All fixed 10BASE-T/100BASE-TX
ports are auto-negotiated; all
fixed 100BASE-FX ports are half
duplex; all 1000BASE-T and
!000BASE-SX ports are
permanently set to full duplex.
Flow Control Enabled in half duplex,
auto-negotiated in full duplex Enabled in half duplex,
auto-negotiated in full duplex
PACE Disabled Disabled
Security Disabled Disabled
Broadcast
Storm Control Enabled Enabled
BOOTP Enabled Enabled
Virtual LANs
(VLANs) All ports belong to the
untagged Default VLAN
(VLAN 1) only; 802.1Q learning
is disabled All ports belong to the
untagged Default VLAN
(VLAN 1) only; 802.1Q learning
is disabled
FastIP Disabled Disabled
Multicast
Filtering 802.1p and IGMP filtering are
both disabled 802.1p and IGMP filtering are
both disabled
Spanning Tree
Protocol Disabled Disabled
RMON Alarm
(broadcast
bandwidth
used) Enabled:
High threshold: 2976 broadcast
frames per second — Notify and
filter
Low threshold: 1488 broadcast
frames per second — Notify and
unfilter Enabled:
High threshold: 2976 broadcast
frames per second — Notify and
filter
Low threshold: 1488 broadcast
frames per second — Notify and
unfilter