Edimax Technology AR-7211B V2 - Manual (Page 35)

35
Field Description
Obtain an IP address
automatically
When this is selected, DHCP assigns IP address for
the PPPoE connection.
Use the following IP address
When this is selected, you need to enter an IP
address for the PPPoE connection, which is
provided by your ISP.
Enable NAT
Check this box to enable network address
translation (NAT). If you do not select it and wish
to access the Internet normally, you must add a
route on the uplink equipment. Usually, it is
required to enable NAT.
Click Next to continue to the next page:
Field Description
PPP Username
Enter the username for PPPoE dial-up, which is
provided by your ISP.
PPP Password
Enter the password for PPPoE dial-up, which is
provided by your ISP.
PPP Connection Type
You can select Continuous (recommended), Connect
on Demand, or Manual.
 Continuous: After dial-up is successful, PPPoE
connection is always on-line, whether the data is
being transmitted or not.
 Connect on Demand: After dial-up is successful, if
no data is transmitted for the preset idle time, the
router automatically disconnects the PPPoE