Edimax Technology AR-7211B V2 - Manual (Page 71)

71
Field Description
Protocol
Choose the transport layer protocol that the
service type uses. You can choose TCP or UDP.
WAN Setting You can choose Interface or IP Address.
WAN Interface
Choose the WAN interface that will apply to the
virtual server.
WAN Port Choose the access port on the WAN.
LAN Open Port
Enter the port number of the specified service
type.
LAN IP Address
Enter the IP address of the virtual server. It is in
the same network segment with LAN IP address
of the router.
5.6.2.3. NAT Forwarding
Click NAT Forwarding in the left pane, and the page shown in the following
figure will appear. Under 1483MER or 1483Routed mode, if NAPT (Network
Address Port Translation) is enabled, the Local IP Address is configured as
192.168.1.3 and the Remote IP Address is configured as 202.32.0.2 - the PC
with the LAN IP192.168.1.3 will use 202.32.0.2 when it is connected to the
Internet via the router without NAPT control.