Edimax Technology AR-7211B V2 - Manual (Page 67)

67
5.6. Advanced
In the navigation bar across the top of the screen, click Advanced. The
Advanced page which is displayed contains Routing, NAT, IP QoS, SNMP and
Others.
5.6.1. Routing
Choose Advanced > Routing, and the page which is displayed contains Static
Route and RIP.
5.6.1.1. Static Route
Click Static Route in the left pane, and you will see the following screen. This
page is used to configure routing information. You can add or delete IP routes.
Field Description
Enable Select Enable to use static IP routes.
Destination Enter the IP address of the destination device.
Subnet Mask Enter the subnet mask of the destination device.
Next Hop Enter the IP address of the next hop in the IP route to
the destination device.
Metric The metric cost for the destination.
Interface The interface for the specified route.
Add Route Click to add the new static route to the Static Route
Table.
Update Select a row in the Static Route Table and modify the
parameters. Then click “Update” to save the settings
temporarily.
Delete Selected Select a row in the Static Route Table and click to