P 121, P 121), Wipers and washers – HONDA 2012 CR-V User Manual

Page 123

Advertising
background image

121

uu

Operating the Switches Around the Steering Wheel

u

Wipers and Washers

Continued

Co
ntrols

Wipers and Washers

The windshield wipers and washers can be
used when the ignition switch is in ON

(

w

.

MIST

The wipers run at high speed until you release
the lever.

Wiper switch (OFF, INT, LO, HI)

Change the wiper switch setting according to
the amount of rain.

Adjusting the delay

*

Turn the adjustment ring to adjust the wiper
delay.

Washer

Sprays while you pull the lever toward you.
When you release the lever, the wipers make
two or three more sweeps before stopping.

Front Wiper/Washer

1

Wipers and Washers

NOTICE

Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.

NOTICE

In cold weather, the blades may freeze to the
windshield, becoming stuck.
Operating the wipers in this condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.

Turn the washers off if no washer fluid comes out.
The pump may get damaged.

If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens. When the vehicle starts moving, the
wipers make a single sweep.
When the vehicle speeds up, the wiper operation’s
shortest delay setting ( ) and the LO setting become
the same.

Models with intermittent time adjustment ring

Intermittent Time
Adjustment Ring

*

MIST

INT: Low speed with

intermittent

OFF

LO: Low speed wipe

HI: High speed wipe

Pull to
use
washer.

Long delay

Short delay

* Not available on all models

CR-V-31T0A600.book 121 ページ 2011年8月8日 月曜日 午後6時26分

Advertising
This manual is related to the following products: