HONDA 2012 CR-V - Manual (Page 312)

uu Replacing Light Bulbs u Fog Light Bulbs *
310
Main
tenan
ce
5. Reinstall the hold-down wire. Hook the end
of the wire on the knob in the slot.
u You can see if the hold-down wire is in
the right place from the inspection
window.
6. Reinstall the rubber weather seal.
7. Insert the coupler into the connector of the
bulb.
Fog Light Bulbs *
When replacing, use the following bulbs.
1. Remove the clip using a flat-tip screwdriver,
and push up the under cover.
Inspection Window
Hold-down
Wire
Fog Light: 55 W (H11)
1 Fog Light Bulbs *
NOTICE
Halogen bulbs get very hot when lit. Oil, perspiration,
or a scratch on the glass can cause the bulb to
overheat and shatter.
The fog lights are halogen bulbs.
When replacing a bulb, handle it by its plastic case,
and protect the glass from contact with your skin or
hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth.
Clip
* Not available on all models
CR-V-31T0A600.book 310 ページ ２０１１年８月８日 月曜日 午後６時２６分