P114 – HONDA 2012 CR-Z User Manual
Page 116
uu
Operating the Switches Around the Steering Wheel
u
Wipers and Washers
114
Co
ntrols
The rear wiper and washer can be used when
the ignition switch is in ON
(
w
.
■
Washer switch (OFF, ON)
The wiper operates intermittently after
completing a few sweeps.
■
Washer (
)
Sprays while you rotate the switch to this
position.
Hold it to activate the wiper and to spray the
washer. Once released, it stops operating
after a few more sweeps.
■
Operating in reverse
When you shift the transmission to
(
R
with the front wiper activated, the rear wiper
operates automatically as follows even if its switch is off.
■
Rear Wiper/Washer
1
If the wiper stops operating due to any obstacle such
as the build-up of snow, park the vehicle in a safe
place.
Rotate the wiper switch to OFF, and turn the ignition
switch to ACCESSORY
(
q or LOCK
(
0, then remove
the obstacle.
The wiper motor is equipped with a breaker that may
stop motor operation temporarily to prevent an
overload. Wiper operation will return to normal
within a few minutes, once the circuit has returned to
normal.
a
ON: Intermittent
b
OFF
c
Washer
Front Wiper Position
Rear Wiper Operation
INT (Intermittent)
Intermittent
LO (Low speed wipe)
HI (High speed wipe)
Continuous
12 CR-Z-31SZT610.book 114 ページ ２０１１年８月２９日 月曜日 午後８時８分