Fig. 3-4 – Activeforever AutoCloser Automatic Garage Door Closer User Manual
Page 12
12
Determine your mounting location by holding the Autocloser unit against the garage door
opener power head assembly with the infrared sensor facing the reflector. While the
Autocloser
is in setup mode, it will emit a continuous audible alarm when the infrared
sensor is within range and lined up with the reflector. Adjust the unit until it emits the
continuous audible alarm. Mark the position of the unit by outlining it with a pencil (Fig.
3-4).
4. Apply Velcro
to the Autocloser unit and the garage door opener power head
assembly (Fig. 4-1). TIP: Apply two parallel strips at the front and back of the outline
and the unit. The industrial strength, temperature resistant adhesive on the Velcro
strap
is pressure activated. Use your finger to apply pressure and remove air bubbles. The ad-
hesive is 80% cured in 1 hour and 100% cured in 24 hours. The Autocloser unit can be
mounted before the adhesive is cured, but care should be exercised not to apply any pres-
sure on the unit that will disturb the adhesive. Attach the Autocloser to the Velcro
strapping on the garage door opener. As in step 3, verify that the reflector and system are
aligned.
Fig. 3-4
Fig. 4-1