Activeforever AutoCloser Automatic Garage Door Closer User Manual
Page 20
20
13. Insure that nobody is standing under the garage door. Plug the garage door
opener back into its 110 Volt household receptacle.
14. Program your I-Opener electronic key. Your I-Opener system will remember
up to nine electronic key codes at a given time. Have all of the keys present when
programming the system. Switch the Autocloser
to setup mode. Press each key
into the I-Opener terminal for 2 seconds. The
Autocloser will beep 3 times after
each key is read. When all of the keys have been read, switch the Autocloser
to
on mode. Test each key by pressing it into the I-Opener terminal. (Remember:
Whenever one key is programmed, all keys must be reprogrammed.) To erase all
key codes from the Autocloser, press the disable button while the unit is in setup
mode.
Fig 12-2
Attach white wire
to GA- and colored
or striped wire
to GA+