Activeforever AutoCloser Automatic Garage Door Closer User Manual
Page 22
22
TIP- The auto close cancel feature can be used whenever the Autocloser begins its
continuous warning beeps.
4) Set the auto close delay time - The delay time can be set to 2, 5, 10, 15 and 20 min-
utes. To set the delay time press and hold the disable button while the unit is in run
mode. The unit will initially beep twice. The unit will sound a series of beeps every 5
seconds to signify the delay time that would be set if the disable button were released
immediately.
1 beep => 2 minutes
2 beeps=> 5 minutes
3 beeps=> 10 minutes
4 beeps=> 15 minutes
5 beeps=> 20 minutes
After reaching 5 beeps, if you have missed the setting you desired, you may release
the button and press it again to restart the sequence.
*NOTE: It is recommended that you set your delay time for as short a delay as pos-
sible, to minimize the amount of time your garage is vulnerable to intruders.
5) Program I-buttons - Nine I-button key codes can be programmed into the system. All
key codes must be programmed at the same time. To program the system, switch the
unit to setup mode. Press each I-button into the I-Opener terminal for 2 seconds.
(When the first I-button is pressed into the terminal, the system erases all previous I-
button key codes.) The unit will beep 3 times after each I-button key code is re-
corded. When finished programming the I-buttons, switch the unit to on mode. Press
each I-button into the terminal. The door should move when each I-button is tested.
6) Erase all I-buttons - If you lose one or more of your I-buttons, you should erase the
key codes while waiting for replacements. Switch the unit to setup mode. Press the
disable button. The system will beep 3 times to indicate that the I-button key codes
have been erased. Switch the unit to ‘ON’ mode.
7)
Autocloser/reflector alignment - To align the unit and reflector, switch the unit to
setup mode and open the garage door. The system will beep continuously when the
reflector is within three feet of, and aligned with, the Autocloser unit. Switch the unit
to on mode.