Activeforever AutoCloser Automatic Garage Door Closer User Manual
Page 24
24
STEP 4
?
Press and release the Disable button
while the unit is on. Does the unit
beep twice?
No- Go to Step 1 and re-
align the reflector.
Yes- Go to Step 5
STEP 5
1) Are you sure you are waiting the
full delay time?
No- Press and hold the
Disable button. The unit will
beep twice initially, then af-
ter 5 seconds it will beep
once. Release the disable
button. This sets the delay
time to 2 minutes.
Yes- Go to Step 6
2) Retest Autocloser function and
wait the full two minutes. Does the
unit work?
• No- Go to Step 6
• Yes- Unit is working
STEP 6
1) Disconnect unit from the garage
door opener.
2) Plug it in to any wall outlet.
3) Hold the unit about a foot away
from the wall and switch it to
‘setup’. It should continually beep.
4) Switch it to 'on'.
5) Hold the unit about a foot away
from the wall.
6) Wait for the delay timer to com-
plete it’s count (Remember to
keep holding the unit facing the
wall. If the unit doesn't think the
reflector is in the open position, it
will not go into closer mode.) The
unit should begin beeping after
the delay timer finishes it’s count.