Fig. 8 – Activeforever AutoCloser Automatic Garage Door Closer User Manual
Page 17
17
Fig. 8
INSTALLATION OF OPTIONAL
I-opener subsystem
HARDWARE
The I-opener subsystem can be installed anytime after the
Autocloser-GA
has been in-
stalled.
!!! WARNING !!!
OPEN YOUR GARAGE DOOR AND UNPLUG THE GARAGE DOOR OPENER
BEFORE BEGINNING THIS INSTALLATION !!!
Determine
I-opener terminal mounting location. The weather resistant I-opener ter-
minal, item 11, can be mounted anywhere on the outside of your garage where a drill hole
can be made. The system cannot be installed on the garage door itself. We suggest using
the garage doorframe. This location will provide limited shelter and the typical wooden
frame will be easier to drill. Using the I-opener terminal plate as a template,
INSTALLATION OF OPTIONAL I-Opener subsystem
HARDWARE
The I-Opener subsystem can be installed anytime after the Autocloser
has been installed.
!!! WARNING !!!
OPEN YOUR GARAGE DOOR AND UNPLUG THE GARAGE DOOR OPENER BEFORE BEGIN-
NING THIS INSTALLATION !!!
8. Determine I-Opener terminal mounting location. The weather resistant I-
Opener terminal, Item (11), can be mounted anywhere on the outside of your ga-
rage where a drill hole can be made. The system cannot be installed on the garage
door itself. We suggest using the garage doorframe. This location will provide
limited shelter and the typical wooden frame will be easy to drill. Using the I-
Opener terminal plate as a template, sketch the approximate position of the termi-
nal (Fig. 8).
9.
Drill holes for the I-Opener wire harness. Visually inspect the opposite side
of the doorframe for wires and other objects that may be damaged by the drill.
Estimate the center of the sketch. Using a 7/16-inch drill, make a 7/16-inch
hole through the center of the sketch. Feed all of the I-Opener terminal wire
through the hole (Fig. 9).
Fig. 8
!!!
!!!WARNING!!!
!!!