ACU-RITE MILLPWR 2 Axes - Manual (Page 129)

PROGRAM STEPS
MILLPWR ®
Operation Manual 5-40
Engrave
With MILLPWR , you have the ability to engrave letters, numbers and symbols, along a
straight line or on an arc. Choose from a simple, stick or stencil font. The character
height, font and modifier settings you select will define the engraving’s appearance.
Condition: The tool diameter being used establishes the spacing between letters.
Engrave Line
To engrave along a line:
• From the PGM screen, press the MORE STEPS softkey.
• Press the MORE STEPS softkey again.
• Press the ENGRAVE LINE softkey.
• Enter the X- and Y-axes coordinates for the point
at the lower left corner of the engraving.
• Enter the character height.
• Enter the tilt angle (if any).
• Enter the depth.
• Highlight “Font”. If you want to change the font,
press the
ENGRAVER FONTS softkey, highlight the font you want, then
press ENTER .
• Highlight “Modifier” and press either the NORMAL or MIRRORED softkey.
"Normal" means that the engraving will be readable from left to right;
"Mirrored" will make the engraving appear backwards.
Use "mirrored"
if you are mak-
ing a mold.