Bosch PPS 7S - Manual (Page 49)

English | 49
Bosch Power Tools 1 609 929 W71 | (30.3.11)
Starting Operation
f Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Starting and Stopping
– To start the operation, press the green ON
button 16.
– To stop the operation, press the red OFF but-
ton 17.
Power Failure
The ON/OFF switch is a so-called non-voltage
switch, which prevents the power tool from re-
starting after a power failure (e. g., when the
mains plug is pulled during operation).
To restart the operation of the machine after-
wards, the green ON button 16 must be pressed
again.
Working Advice
General Sawing Instructions
f
For all cuts, firstly ensure that the saw
blade cannot touch or graze against the
stops (guide rail 31 or fence 36 of the uni-
versal guide) or any other machine parts.
f Use the machine for grooving or rebating
only with an appropriately suitable protec-
tive device (e. g. a tunnel blade guard).
f Do not use the machine for cutting slots
(stopped grooves).
Protect the saw blade against impact and shock.
Do not subject the saw blade to lateral pressure.
The riving knife must be in alignment with the
saw blade to avoid jamming of the workpiece.
Do not work bent or warped workpieces. The
workpiece must always have a straight edge to
place it flush against the universal guide.
Always keep/store the push stick with the pow-
er tool.
Position of the Operator (see figure P)
f
Do not stand in a line with the saw blade in
front of the machine. Always stand aside of
the saw blade. This protects your body
against possible kickback.
– Keep hands, fingers and arms away from the
rotating saw blade.
Observe the following instructions:
– When sawing narrow workpieces and bevel
angles, always use the supplied push stick 12
and the universal guide 1.
– Operation as a Pull Push Saw:
Hold the workpiece and press it firmly
against the fence.
– Operation as a Table Saw:
Hold the workpiece securely with both hands
and press it firmly against the saw table.
Maximum Workpiece Dimensions
Operation as a Pull Push Saw
Operation as a Table Saw
Sawing
Operation as a Pull Push Saw
When sawing with sliding action, you pull the
saw blade from rear to front through the held
workpiece.
This operating mode is suitable for:
– Precise cuts
– Separating cuts
Workpiece height Cutting length (max.)
20 mm 212 mm
40 mm 199 mm
60 mm 168 mm
Bevel angle Workpiece height
(max.)
0° 62 mm
45° 36 mm
OBJ_BUCH-1259-002.book Page 49 Wednesday, March 30, 2011 11:02 AM