Dell OptiPlex GX240 - Manual (Page 59)

D r i v e s 59
C a b l e R e p l a c e m e n t
Small Mini-Tower Computer
1 If the replacement drive does not have the bracket rails attached,
remove the rails from the old drive by removing the two screws that
secure each rail to the drive. Attach the bracket to the new drive by
aligning the screw holes on the drive with the screw holes on the
bracket rails and tightening all four screws (two screws on each rail).
2 Gently slide the floppy drive into place until the tabs click securely
into position.
3 Attach the power and floppy-drive data cables to the floppy drive, and
connect the other end of the data cable to the connector on the system
board.
1 Power cable
2 Floppy-drive data cable
3 Floppy-drive connector
1
2
3