American Magnetics 420 Power Supply Programmer - Manual (Page 126)

108 Rev. 7
Appendix
Program Out BNC Connector
A.4 Program Out BNC Connector
The Program Out female BNC connector provides up to a
−
10 VDC to +10
VDC output designed to drive the remote voltage-to-voltage programming
input of a connected power supply. Refer to the Installation section for
detailed descriptions of the system interconnections, or refer to the
manual for your power supply. The coaxial shield is the output return. The
center conductor is the program out voltage.
Note
For maximum noise immunity, the Model 420 chassis and the
chassis of any connected power supply should be tightly electrically
coupled. This can be accomplished through the rack mounting or by
using a grounding strap between the chassis.
Note
Do not connect J6 to the Model 601 rear-panel coaxial connector.
QSPBS6HÃPVU
E%