AASTRA 600c_d for SIP-DECT User Manual EN - Manual (Page 12)

6
Installation
Installation
Inserting the standard battery
Aastra 610d, 612d, 620d, 622d, 650c
Push the battery cover downwards until it disengages
from the locking mechanism and lift off. Insert the bat-
tery with the contacts downwards. Replace the battery
cover and push upwards until it snaps into place.
Aastra 630d, 632d
Undo the two screws on the back of the handset with a
suitable tool and remove the cover. Insert the battery
with the contacts downwards, close the battery com-
partment with the cover (insert underneath, press
down from above) and screw back in place. Do not
damage the rubber seal when assembling.
Inserting the power battery
You can order a battery with higher capacity
(power battery) for the
Aastra 620d, 622d, 630d ,
632d and 650c as an accessory (see page 83).
This battery has a thicker design so you need another
battery cover that protrudes approx. 6 mm beyond the
rear of the device.
Install the new battery cover as described above.
Please remove any installed fixing bracket before inser-
ting the power battery and securing the battery cover.