AASTRA 600d for OpenCom 1000 User Guide (with bookmarks) EN - Manual (Page 38)

32
To dial these call numbers briefly press the hotkey, select the desired entry and press the call key
: the call will be set up.
Calls from call numbers on the VIP list are signalled using the VIP ring tone. The relevant setting is
made in the Menu ❯❯❯ -> Audio -> Ringer setting -> Melodies.
Note
You can also program the VIP list with phone numbers using the Directories menu (see page 64).
VIP list
(Aastra 610d)
The programmable keys of the Aastra 610d can also be assigned with a VIP phone book. To do so,
program one of these keys as described on page 94 and then save the name and call number as des-
cribed in the previous paragraph (or in the Directories menu).
Profiles
Profiles consist of a group of handset settings each assigned to a particular situation or application.
For instance you can switch from “Normal” mode (e.g. in the office) to “Loud” mode when you enter
a different environment (e.g. a factory floor). As a result of the switch, features such as ringer
volume, vibra call, speech quality, LED signalling, etc., adapt to the new environment. Your handset
has five profiles.
While they are predefined, they can be changed at any time. If required, change the default settings
to suit your handset applications (see page 85).
Note
If when a profile is activated you change a number of features contained in the profile using the nor-
mal menu access (e.g. using ❯❯❯ Audio > Volume > Ringer), the settings are adopted by the pro-
file.
Adapting to your environment
Your handset has two functions which can be used to adapt the handset to loud environments:
If you activate the function using the menu ❯❯❯ Audio > Ringer settings > Noise detection, the
ringer volume is automatically increased in loud ambient noise. Make sure in this case that you have
not set the ringer volume to “Increasing”.
If you activate this feature using the menu ❯❯❯ Audio > Loud environment, the handset will
attempt to improve the speech quality in a loud environment. This applies to connections via the
Basic functions