AASTRA 600d for OpenCom 1000 User Guide (with bookmarks) EN - Manual (Page 77)

71
Devices menu
"System" menu
New system
Enter the access code and optionally the PARK code. Contact your System Administrator for
more information on this and the protocol setting.
Subscription
Auto search
The handset automatically logs on to the system with the strongest signal cur-
rently available. Logon is possible only if the handset has subscribed to the sys-
tem in question beforehand. Please contact your System Administrator if requi-
red.
[System 1…10]
List of systems to which the handset is already subscribed. The selected system
is highlighted.
Use the navigation keys to select a system.
With
the handset tries to establish a connection.
Other options can be obtained and set by pressing ❯❯❯. As a rule they do not
have to be changed. The following settings should only be made by the System
Administrator:
System Name and Phone number lets you change / enter the system name
and phone number. This is possible only if no details are supplied by the system
itself.
External call is used to set the code that identifies external calls (e.g. 0).
Internal call is used to set the number of digits that make up an internal phone
number. Both settings allow the device to differentiate between internal and
external calls.
Character set is used to set the Editor’s character set.
Protocol is used to set the transmission protocol. Details shows additional
device data. Delete is used to delete the subscription for the corresponding sys-
tem.
Stop searching
Used to specify that the handset is not present within the system. This feature is
useful in some systems if the system fails to detect that the device is switched
off and in this case activates a call diversion for example.
Show IPEI
The international handset ID is displayed. This may be required for identifying your handset
in the telephone system.
Version info
Information concerning the handset hardware and software status is displayed.