AASTRA 6739i for Aastra 800 and OpenCom 100 User Guide EN - Manual (Page 26)

Operating Aastra 6739i SIP Telephone
24
Call Forwarding
The administrator of the OpenCom 100 / Aastra 800 communications system can con-
figure a Call forward function key (please refer to Programming Function Keys
starting on page 45).
1. Press the Call forward function key.
The display shows a separate line with Immediately, After delay or Busy for each
type of call forwarding along with the current status (“+” = on, “-” = off ). A separate
call forwarding can be configured for each type of call forwarding.
2. Press the softkey on the display line showing the desired call forwarding type .
3. Program the following call forwarding parameters by pressing the respective
softkey next to it.
– Dest.: Enter the call number to be forwarded to.
– Duration: When programming call forwarding after time, enter the time in
seconds after which a call is to be forwarded (10 sec … 120 sec). If you do not
enter a value, the default time interval provided by the system administrator at
system configuration is used (default: 20 seconds).
– Internal calls / External calls / int./ext. calls: Select which calls are to be for-
warded.
– On/Off: Switching call forwarding on or off. Active call forwarding is indicated by
a “+” sign. This is followed by the call forwarding destination.
4. Press the goodbye key to exit the menu card.
Tip: Call forwarding can also be set using the main menu: 2 Call
forwarding > 1 Call diversion (see page 35). The Follow Me
type call forwarding can also be set there.
Notes
• All calls for the call numbers of your device are forwarded. If a number is in use on
more than one telephone, then calls made to any of the other telephones will be
forwarded as well.
• You can activate all types of call forwarding simultaneously. In this case, the
Immediately type call forwarding is always executed.