Hotchkis 22400 Toyota Celica Sport Sway Bar Set User Manual
Page 9
Advertising
6)
Lift the new Hotchkis bar into position in the vehicle in the same manner as the stock sway bar
was mounted.
7)
Use a 12mm socket or wrench and the stock hardware to secure the brackets holding the sway
bar in place in the rear. Torque the bolts to 14 ft/lbs.
8)
Use a 14mm wrench and a 6mm Allen wrench to re-attach the end links to the rear sway bar.
Torque the hardware to 32 ft/lbs. If you purchased Hotchkis kit number #25400 (street end
links), then you should follow the instructions included with that kit at this time to replace your
end links.
9)
Re-place the exhaust system by attaching it to the rubber hangars. Bolt the flange back together
and torque the hardware to 25 ft/lbs.
Advertising