Installation of hotchkis rear sway bar – Hotchkis 22400 Toyota Celica Sport Sway Bar Set User Manual
Page 7
Please call us at (877) 4NO-ROLL if you have any questions regarding the service or
installation of your Hotchkis products. Visit us on the web @
Tools required for this installation:
Hydraulic jack, jack stands, torque wrench
The following sockets or wrenches: 12mm, 14mm
The following Allen wrenches: 6mm
INSTALLATION OF HOTCHKIS REAR SWAY BAR
1)
Securely block the front wheels of the vehicle. Use a jack to lift up the rear of the vehicle and
support with jack stands. As with the front installation, you should not remove the rear wheels.
2)
Unbolt the exhaust flange by loosening and removing the two retaining nuts. Retain the
hardware for later re-installation. Proceed to remove the back portion of the exhaust system by
loosening the system from the rubber exhaust hangars. You will be re-installing this system
later, so take care not to damage your exhaust when removing it.